Heat tape and heat trace for pipes, roofs, gutters and downspouts across Anchorage and the Mat-Su.
Heat tape is an electric heating cable that wraps a water pipe or runs along a roof edge to keep it above freezing. In Anchorage it prevents frozen pipes and ice dams. It needs a ground-fault protected circuit, and a thermostat or controller keeps it from running when it is not needed.
A heat cable on a pipe or a roof edge needs its own protected circuit and a way to switch on when it counts. We wire it properly, so it is not an extension cord through a crawlspace window.
Done right, cleaned up, and explained in plain English.
Water lines, well lines and crawlspace plumbing that freeze every cold snap.
Zigzag runs along the eaves, through the gutters and down the downspouts.
Dedicated circuits with ground-fault protection, labeled at the panel.
The cable only runs when the temperature calls for it.
Cracked, discolored or tripping tape swapped before it fails.
A test of every run before the first hard freeze.
They do the same job. Heat tape usually means a simple plug-in cable on a pipe. Heat trace usually means a self-regulating cable on its own circuit with a controller, built for roofs and long runs.
It can if it runs all winter. A thermostat or controller turns it on only when it is cold enough to matter, which cuts the cost.
It wears out. A cracked jacket, discolored spots or a GFCI that keeps tripping are signs it is time to replace it.
Yes. We run the circuit and controls and install the cable along the eaves, gutters and downspouts.